U-verse TV error messages

If you see a U-verse TV error message, use the AT&T Troubleshoot & Resolve tool to find a quick fix, or get some tips here.


Quick fix tips

These quick fixes will resolve many U-verse TV errors

  • Restart your U-verse receiver(s) by holding down the POWER button for ten seconds, then pressing again to restart. (This takes 5-8 minutes and will impact any DVR recordings in progress.)
  • Restart your Wi-Fi gateway by removing the power cord for two minutes then plugging it back in (will interrupt AT&T service).
  • Check for snug and secure video cables connecting your TV, gateway, and receiver.

On screen error messages

Gear or cog displayed on screen
Gear or cog wheel displayed on U-verse screen

If you see the gear or cog icon on your screen, it means that software is downloading to your system. Most downloads finish in less than an hour. If you're seeing the icon for more than an hour, unplug the receiver and wait five minutes, plug it back in, and then restart.

Blinking lights on the receiver with no TV picture
If the lights on your U-verse receiver are blinking and no TV picture is displayed, your receiver is having trouble coming online. Unplug your receiver and wait five minutes, plug it back in, and then restart.

Three dots displayed on screen
3 dots shown horizontally on U-verse screen

If you see three dots on your screen, it means your system is connecting. This screen should display for several seconds, followed by a blank screen displayed for several minutes as the process continues.

Red X, Client Initialization Error, or Diagnostic Info Screen displayed
Red X with the number 13 underneath displayed on U-verse screen

If these screens display, your system is having trouble communicating. Try unplugging your receiver and waiting two minutes, plugging it back in, and then restarting. If that doesn't solve the problem, unplug your Wi-Fi gateway and wait two minutes, then plug it back in and restart. This will temporarily disrupt internet, TV, and Voice service.

The recording conflict could not be cleared
If you see the message The recording conflict could not be cleared, try canceling one or more recordings, or turning off one or more receivers.

Content unavailable message
If you see a message that says you aren't subscribed to a channel, you can subscribe to it using the U-verse TV Account Manager on screen tool. To access your U-verse Account Manager, go to Ch. 9910.
Last updated: December 7, 2022

Did you get the help you needed?