Firewall & Router
Which device do you want help with?
Change device

Firewall & Router

Learn how to install the AT&T Cell Booster Pro behind a firewall, or behind a router with firewall capabilities.
Prenote info
Installing the AT&T Cell Booster Pro behind a firewall, or behind a router with firewall capabilities, requires the following ports be opened to prevent the firewall from blocking communication with the network.

Note: Customers attempting to connect a AT&T Cell Booster Pro on their corporate Internet connection may experience connection issues. The AT&T Cell Booster Pro is designed to function using a direct Internet connection.

If your device does not activate or was active and is now no longer working, and the LEDs on the front of the device are not all white, please try the following steps:

  1. Power cycle the device by pressing and holding the Reset button on the back of the device for 5 seconds.
  2. Reset the device by pressing and holding the Reset button on the back of the device for 30 seconds.


For more information, click here.


Local transport requirements


Confirm the following router/switch settings prior to activating your AT&T Cell Booster Pro:


1. DHCP is ON.


Note: For installations where static assignment of an IP address is desired the use of MAC Binding and static DHCP Reservation is suggested. Static IP is not supported.

 

2. MTU size is set to 1500 or higher.


3. MAC address filtering is either turned off or allows the MAC address of the Cell Booster.


4. IPSec Pass-Through is Enabled.


5. Block Fragmented Packets is Disabled.



 



UDP Ports

The UDP ports 500 and 4500 are used to establish the IPSec tunnel. The NTP port is required to be open as the NTP sync messages are sent on the public internet for frequency synchronization. All traffic except NTP will go through the IPSEC tunnel and hence only these ports should be unblocked for the AT&T Cell Booster Pro to provide service.

Note: If you have a firewall enabled, the below UDP Ports need to be open to prevent the firewall from blocking communication with the network. Please contact your Internet Service Provider for assistance.


• UDP/ 500 IPSec Port

• UDP / 4500 IPSec Port

• UDP/ 123 NTP Port (Timing Synch)

Did you get the help you needed?